Re-inspection with a chopper machine for battery separator

Solution

•  Although the input material is already scrutinized. The Re-Inspection with a Chopper machine for Battery Separator will inspect the papers again to remove any possibility of defect.
• Every single roll are unwinded upon this machine as final level verification
• The verification is done by laser-based equipment that sends a signal to the PLC if it detects any abnormalities
• Mark sensors are installed for spray mark checking, if the hole size is greater than the tolerance limit then the paper is cut and re-joint by the welding process

  
  Slitting process :

  • 1) The single roll is slitted first into two or three panels.
  • 2) These panels have a specific width as per cutter adjustment depending upon the requirement.

  
  Chopping process :

  • 1) The small panels obtained after slitting the single roll are operated for chopping
  • 2) The required height and quantity are fed into the machine and cut pieces are obtained

Value addition

• This machine provided Battery Separator an inspection system that ensures that their product is compliant and defect-free.
• All the actuators and gadgets on the machine can be controlled through the control panel
• The operating efficiency of the re-inspection machine is so accurate that it has an error ratio of 1:1000